Of the above types, the common emitter type is the most popular and most used configuration. Some of the configurations used in amplifier circuits are: It can amplify power, voltage, and current in different configurations. 2N3904 as Amplifier:Ī Transistor acts as an Amplifier when operating in an Active Region. Where, the value of VBE should be 5V for 2N3904 and the Base current (IB depends on the Collector current (IC). The value of this resistor (RB) can be calculated using the below formulae. Anything more than 5mA will kill the Transistor hence a resistor is always added in series with base pin. As mentioned the biasing current should maximum of 5mA. As discussed, a transistor will act as an Open switch during Forward Bias and as a closed switch during Reverse Bias, this biasing can be achieved by supplying the required amount of current to the base pin. When a transistor is used as a switch it is operated in the Saturation and Cut-Off Region as explained above. When the base current is removed the transistor becomes fully off, this stage is called the Cut-off Region and the Base Emitter voltage could be around 600 mV. This stage is called Saturation Region and the typical voltage allowed across the Collector-Emitter (VCE) or Collector-Base (VCB) could be 40V and 60V respectively. When this transistor is fully biased it can allow a maximum of 200mA to flow across the collector and emitter. To bias a transistor we have to supply current to the base pin, this current (IB) should be limited to 5mA. The maximum amount of current that could flow through the Collector pin is 200mA, hence we cannot connect loads that consume more than 200mA using this transistor. 2N3904 has a gain value of 300 this value determines the amplification capacity of the transistor. Brief Description on 2N3904:ĢN3904 is an NPN transistor hence the collector and emitter will be left open (Reverse biased) when the base pin is held at the ground and will be closed (Forward biased) when a signal is provided to the base pin. Note: Complete Technical Details can be found at the 2N3904 datasheet given at the end of this page. Features: Bi-Polar NPN Transistor DC Current Gain (hFE) is 300 maximum Continuous Collector current (IC) is 200mA Base- Emitter Voltage (VBE) is 6V. Continuous Collector current (IC) is 200mA.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |